Left Flipper End of Stroke
Flipper (J806) ·
Wiring
- Wire
- Black-Blue J806-3
Location
- Not on the playfield map: on the flipper assembly under the playfield.
- Not shown on the location map
From the manual
EOS (End of Stroke) on the flipper mechanism under the playfield. Contact gap 0.062″ ± 0.015″ (about 1.2–2 mm), adjusted at least 0.25″ (6 mm) from the switch body (p. 2-16). The parts list gives SW-1A-194 (make) for the lower flippers and SW-1A-193 for the upper ones; the flipper page in the manual lists only SW-1A-193 for the base model. The sources disagree. (the manual's own pages and parts lists, not the owner's experience)
Service log
Everything you record stays on this device.
Service notes: Read by the Fliptronics board through J806-3, not by the switch matrix, and it carries no coil current. Gap 1/16 inch at rest, closing just before the end of travel; clean with card stock, never a file. A flipper that drops under a hard hit is often this switch never closing, a lazy flipper is it stuck closed. The manual is inconsistent on whether it is normally open or closed, so look at yours at rest. A6 Flippers
Appendices:A6 FlippersA3 Switches and optosA5 Power driver boardA1 Multimeter basics